GOMinimumMove

A - B - C - D - E - F - G - H - I - K - L - M - N - O - P - Q - R - S - T - U - V - W - X

GOMinimumMove

Section Calculation Modes::Geometry Optimization
Type float

Convergence criterion, for stopping the minimization. In units of length; minimization is stopped when the coordinates of all species change less than GOMinimumMove, or the GOTolerance criterion is satisfied. If GOMinimumMove < 0, this criterion is ignored. Default is -1, except 0.001 b with GOMethod = simplex. Note that if you use GOMethod = simplex, then you must supply a non-zero GOMinimumMove.


Source information

Featured in tutorials

Featured in chapters of the manual: